Visit to Greg

1. 

   Jim

   June 5, 2009 at 8:36 am

   I like the bowls withe the colored internal rim, did you figure out the texturing process and the dying process or did you read about it on the internet. If it is on the internet can you send me the website?

   Beautiful work
2. 

   admin

   July 26, 2009 at 12:24 am

   I figured it out myself. The rim was turned with a bead interposing the center bowl and the rim. A power carver with a V bit was used (while on lathe) to carve the texture, turning the bowl using the tool rest as a guide for the carver. The outer and inner sections were masked and the textured areas dyed. Then the piece was returned to give sharp edges where the dye and un-dyed sections met.

This site uses Akismet to reduce spam. Learn how your comment data is processed.